Washer shacking while spinning.

First I pulled the washer to an open area.
Then removed fluid line going to tub.
Removed tub by removing springs.
Turned tub upside down, removed the belt pulley, and held the ring under the snubber ring with C clamps while removing 6 screws holding assembly together. Released the pressure on the C clamps slowly until spring pressure was gone.
Replaced snubber, and installed ring holding assembly. Replaced ring plate, and C clamps going back in place with equal pressure until seated. Replaced 6 screws, and pulley assembly, and all fluid lines and new spring kit.
WALA..... WORKS GREAT for less than $25.

Thanks