Control Panel Buttons Not Working

ApplianceMaytag Range

ModelMMW5530DAW

Level of DifficultyEasy

Time to do repair15 - 30 mins

Age of Appliance1 - 4 years

Tools Wrench set
Nutdriver

David From San Diego, CA

Feb 02, 2010

3 out of 5 people found this instruction helpful

Make sure oven is unplugged or breaker switch is OFF.

Pull the oven roughly 1/3 of the way out.

There are two bolt screws on each side of the control panel that become visible upon pulling the oven out. Remove these bolts with a nut driver.

Carefully pull the panel 180 degrees downward and being careful with the attached wiring.
Unplug the two strip cables going into the control box by lifting up on the plastic holders.

Find the outer-most bolts, 2 on each side of the control panel innards, and remove them and then remove the entire control panel.

Remove the silver heat shielding from the old control panel and put it in the same way on the new one. Re-connect the two strip panel cables the same way it was connected, make sure everything else is still plugged in!

Re-bolt the the panel to the control box with the 4 outer screws.

Line up control panel and re-bolt the 4 outer-screws on the side of the oven

Gently push the oven back in place.

Cook brownies to celebrate!!

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Control Panel with Touchpad

Part Number: PS2357915

$163.46
In Stock