Inlet valve was not shutting off. Door counterbalance was broken

ApplianceKitchenAid Dishwasher

Model

Level of DifficultyA Bit Difficult

Time to do repair1- 2 hours

Age of Appliance5 - 10 years

Tools Wrench set
Pliers
Nutdriver
Screw drivers

Brian From Los Angeles, CA

Dec 19, 2009

4 out of 7 people found this instruction helpful

I turned off the circuit breaker for the dishwasher.
I also shut off the water inlet valve to the feed line.
Disconnected the electrical and conduit. Disconnected the drain line and the water feed line to the inlet valve. I made sure I had old towels under the unit to catch any water flowing out of the pipes once disconnected.
I removed two screws holding the dishwasher up under the counter edge.
Then the dishwasher rolled out of from under the counter, I rolled it over to an area where I had laid down a moving blanket.
I noticed the new counterbalance "ropes and pulleys" were a bit different design than the originals so I made sure the new style pulleys would fit and they did. I replaced both sides pulleys and link ropes, then I connected the spring to the rope and pulled the spring back to connect to the rear of the frame of the dishwasher. Door fixed!
The inlet valve is a piece of cake, just removed one screw and the electrical connector and replaced, reversing the process.
I cleaned up under the counter where the dishwasher mounts and also shot some "Foam" into some areas where I think sounds might have been leaking into the living room on the back side of the counter, I figured it could not hurt to seal off those areas to prevent as much sound as possible from entering the other living space. I reversed the process installing the dishwasher and then ran a cycle making sure that no water was leaking from the inlet or the drain lines.
It all seems to be working now.
While the dishwasher was out I wanted to figure out what this "Clunk" was every time you opened the door was, turned out it was something to do with the door catching the front edge of the bottom pan of the dishwashers and then it would clunk as it sprung back. I just used my hands and kinda bent the front edge of the bottom pan of the dishwasher back in and now they don't touch and the clunk is gone. So for about $60.00 in parts and 1.5 hours of my time the dishwasher is back in operation.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Water Inlet Valve

Part Number: PS887857

$37.59
In Stock

Door Balance Link Kit

Part Number: PS972325

$19.16
In Stock