Would not go into spin and drain cycle. When pushed down further manually it worked--it was worn.

ApplianceWhirlpool Washer

ModelEstateBy

Level of DifficultyA Bit Difficult

Time to do repair30 - 60 mins

Age of Appliance5 - 10 years

Tools Wrench set
Screw drivers

Michael From Coeur d'Alene, ID

Dec 17, 2009

0 out of 1 people found this instruction helpful

Unplug washer. Remove screws from the front control panel and tilt back. Switch is located on top right of washer when open. Trace back wires from switch to control panel and disconnect. Then remove wire harness form metal clips and unscrew switch from washer. Also carefully remove green ground wire from inside washer by tilting drum to right to give you more room. Use open end wrench to loosen grd screw and then turn by hand. You do not need to remove the top as described in other stories, but you may need to remove gold clips under control panel to release the back panel a little to reach in and remove connector and clips holding on wire harness. With good light, look through front crack separating washer front and top to view inside this description and procedure.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Lid Switch Assembly with Leads

Part Number: PS350434

$30.40
In Stock