THE PROBLEM STARTED WITH THE PUMP GETTING NOISY THEN IT STOPPED PUMPING ALL TOGETHER THERE ARE TWO PUMPS IN THIS MACHINE STILL DRAINED ITS SELF.

ApplianceWhirlpool Dishwasher

ModelDU1055XTSB3

Level of DifficultyReally easy

Time to do repair30 - 60 mins

Age of Appliance1 - 4 years

Tools Nutdriver
Screw drivers

JOHN From MORA, MN

Dec 10, 2009

2 out of 5 people found this instruction helpful

FIRST RUN THE CANCEL AND DRAIN CYCLE TO EMPTY THE WATER FROM THE MACHINE. NEXT SHUT OFF THE WATER AND POWER TO MACHINE. THEN DISCONECT THE WATER AND DRAIN HOSES, AND UNINSTAL THE MACHINE FROM THE CABNET. THERE ARE USUALY JUST TWO SCREWS AT THE TOP WHEN YOU OPEN THE DOOR. BEFORE YOU TAKE THEM OUT TAKE OUT THE BOTTOM WASH ARM, AND THE SCREAN AND THE COVER OVER THE FOOD CHOPPER. THESE ARE ALL HELD IN WITH STAR SCREWS. AFTER THE COVER IS TAKEN OUT THE CHOPPER WILL LIFT RIGHT OUT.

NEXT LAY THE MACHINE ON ITS SIDE THERE IS JUST ONE CAPSCREW HOLDING THE MOTOR IN LOCATED BEHIND IT WHEN LYING DOWN BUT FIRST UNPUG THE WIRE HARNES TO IT.
THE MOTOR WILL COME OUT WITH JUST A SMALL TWIST AFTER THE CAP SCREW IS OUT.
TO INSTAL JUST TWIST IN PUT IN THE CAP SCREW AND FOLLOW THE DIRECTIONS BACKWARD TILL IT IS INSTALLED AGAIN.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Circulation Pump Motor (Now subbed to Circulation Pump Motor with Impeller - 60Hz 120V)

Part Number: PS2363114

$137.62
In Stock