Screws holding recepticles in place had to be drilled out.

ApplianceJenn-Air Range


Level of DifficultyA Bit Difficult

Time to do repair1- 2 hours

Age of ApplianceMore than 10 years

Tools Pliers
Screw drivers

Dennis From Bacliff, TX

Dec 02, 2009

0 out of 1 people found this instruction helpful

Removed screws by drilling one and using a pliers to remove 2nd one. At first did not have enough wire to pull recepticles out until I relized wires were clipped to back of range to hold in place. Unclipped wires, pulled recepticles out, cut wires and attached new recepticles by connecting wires with wire nuts (I think wire nuts were to small so I used my own a size larger). Another problem that I found was that the recepticles on my range were held in place only by the screws that attached the recepticles to the drip pan flang. I had to bend an L bracket to prop under each recepticle to hold the back of it up so the burner element would sit level over the drip pan.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Surface Burner Receptacle Kit

Part Number: PS1570190

In Stock

Drip Bowl - 6"

Part Number: PS1854703

In Stock

Drip Bowl - 8"

Part Number: PS2079053

In Stock