Drum rollers were wore out and squeeling

ApplianceAmana Dryer


Level of DifficultyEasy

Time to do repair30 - 60 mins

Age of ApplianceMore than 10 years

Tools Pliers
Screw drivers

Richard From Houston, TX

Dec 01, 2009

0 out of 1 people found this instruction helpful

I first removed the screws on the bottom section of the dryer. Then I removed the face/door remembering how the two wires on the dryer were hooked up. After that there are two screws that allow the top to flip up on some megshift hinges. this reveals the drum and the guts of the machine. Reaching under the drum I disconnected the belt by pulling the tension wheel down to release the pressure on the belt. Once that is done you can just pull out the drum. The rollers are on the back wall. You have to remove the lock washers on each wheel (provided you change both((I recommend)). Then the rollers just pull off. Remove the the two screws (1/4 in) . It's just a reversal from there. Always clean up all the lent/debris with a vacuum while your there. It's just a good thing to do. Thats it. good luck

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Thrust Washer

Part Number: PS333174

In Stock

Retaining Ring

Part Number: PS2025108

In Stock

Drum Support Roller

Part Number: PS2039408

In Stock

Roller Bracket and Shaft Assembly

Part Number: PS2041342

In Stock