Brown out in my house caused control panel for the oven to blow up.

ApplianceJenn-Air Range

Model

Level of DifficultyReally easy

Time to do repair15 - 30 mins

Age of ApplianceMore than 10 years

Tools Pliers
Nutdriver
Screw drivers

David From Woodinville, WA

Nov 25, 2009

9 out of 11 people found this instruction helpful

I pulled about 8 screws from the front of the stove which held the stainless steel cover to the gas controls on the front of the stove. Then I pulled 4 hex head screws which held the same cover on. The cover tipped toward me and revealed the wiring and control panel. I took each wire off one at a time with needle nose pliers and connected each wire one at a time to the corresponding location on the new control panel. I didn't want to get anything mixed up. There are two multi-wire plugs and they only go on one way so you can't really get those wrong. Once all the wires were reconnected to the new panel, I mounted it to the stainless steel cover, reinstalled the cover, and turned the power back on. Voila! Works like a charm! The whole job took about 20 minutes and I was chatting with my family as I did the job so I was a bit distracted. Expensive part but very easy to change.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Electronic Control Board

Part Number: PS2357546

Recycling Rebate Available No Longer Available