Washer would not drain ,F02 and SUD code displaying

ApplianceWhirlpool Washer

ModelGHW9100LW

Level of DifficultyA Bit Difficult

Time to do repair1- 2 hours

Age of Appliance5 - 10 years

Tools Pliers
Socket set

Donald From Wichita, KS

Nov 08, 2009

97 out of 101 people found this instruction helpful

(1) First I unpluged the washer then I removed the water from the tube with a water vac.(2) Then I removed the three (3) screws that holds the front panel, using a Torx T-20 socket. ( this is a front load washer ). The panel is below the loading door.
(3) I packed towels under the washer.
(4) I slowly removed the cleanout in the front of the pump, using the water vac to catch the water as it leaked out.
(5) I removed the wiring to the motor.
(6) I removed the screw that holds the pump in place with a Torx T-20 socket.
(7) I pulled the pump forward so the clamps that hold the drain hose and discharge hose could be removed using the hose clamp pliers. ( they come off much easier then they go back on ).
(8) I tested the pump and found it would run but was making a lot of noise and running slow.
(9) To reinstall start with number (7) and work backwards to number (1) skipping (3) and (4).
Don Kramer
Wichita, Kansas

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Drain Pump Kit

Part Number: PS1485610

$137.11
In Stock