Water would intermittently stop flowing into machine

ApplianceMaytag Washer

Model

Level of DifficultyEasy

Time to do repair15 - 30 mins

Age of Appliance1 - 4 years

Tools Pliers
Screw drivers

Nicholas From Duarte, CA

Sep 17, 2009

20 out of 25 people found this instruction helpful

Unplugged power cord, turned off water and disconnected cold and hot water lines. Removed two screws on bracket at water inlet area on back of washer. removed loose bracket and removed one screw that held water control valve (hot and cold). Unplugged four clipon electrical connections (marked before removal for ease of reconnection) Used flat tip screwdriver to remove hose clip from hose that went from valve into machine. Connected four clip on electrical connections and reconnected intake washer hose to water valve. I put a tiny bit of plumbers grease on plastic valve nipple to make it easier to push nipple into rubber hose. Reattached one screw to anchor valve to metal bracket. Repositioned bracket and attached two screws that anchored it to the washer. Reconnected hot and cold water lines and turned on hot and cold water to check for leaks. Plugged in power cord and started a wash cycle to once again check for leaks before pushing machine back into place. Wife didn't think I was "talented" enough to fix the washer, but I proved her wrong.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Water Inlet Valve with Thermistor

Part Number: PS2021369

$59.11
In Stock