Original drain pump housing broke causing leak all over laundry room floor

ApplianceWhirlpool Washer

Model

Level of DifficultyReally easy

Time to do repair15 - 30 mins

Age of Appliance1 - 4 years

Tools Pliers
Nutdriver
Screw drivers

tom From Vienna, VA

Jul 29, 2009

22 out of 24 people found this instruction helpful

What a mess!
Unplug the unit, disconnect the hot and cold water supply lines. Remove the drain hose from the wall and slide the unit away from the wall.
It's easier if you lay the unit on it's side, but not required.
Using the flat blade screwdriver, or a 1/4" nut driver, remove the 8 bolts that hold the back cover and lay that aside.
Locate the leaky pump. There are 2. One is the supply pump. One is the waste drain pump and they are not interchangeable.
Using the pliers, slide the spring clamps off of the 2 hoses connected to the pump.
Using a phillips-head screw driver, remove the 3 screws holding the pump to the unit.
Hinge open the cover to the electrical supply for the pump and pull out the connector. It only goes on one way, so reassembly is not an issue.
Throw pump across the street.
Take new pump and reverse instructions above.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Drain Pump (Now subbed to Drain Pump)

Part Number: PS5136124

$89.08
In Stock