Floor floded when washer started.

ApplianceMaytag Washer

ModelA506

Level of DifficultyEasy

Time to do repair15 - 30 mins

Age of ApplianceMore than 10 years

Tools Screw drivers

Keith From Big Sur, CA

Jun 17, 2009

3 out of 5 people found this instruction helpful

Thirty year old Maytag washer. Remove two screws at bottom of front panel with Philips screw driver. Hinge panel up to disconnect front panel from top of machine. Tilt washer back against wall to gain access to pulley at underside of washer. Then remove Philips head screw from bottom of center shaft. Remove bevel washer with screw. Remove stop block from end of center shaft and wind the pulley off center shaft. Clean center shaft of any debris and lightly coat with grease. Install belt on new pulley and motor, wind new pulley on center shaft. Replace stop block, washer, screw, and front cover.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

USE WPL 6-2301530 (Now subbed to Transmission Drive Pulley)

Part Number: PS2347248

$56.43
In Stock