Element had burnt out....break in actual element

ApplianceJenn-Air Range


Level of DifficultyReally easy

Time to do repairLess than 15 mins

Age of Appliance5 - 10 years

Tools Wrench set
Screw drivers

Garth From Cypress, TX

May 13, 2009

7 out of 9 people found this instruction helpful

I first removed the plug in module on the left hand side. I then removed the six screws holding the tempered glass in place. Lifting straight up it then exposed the two elements. I unplugged the two wires connecting the large broken element and lifted up gently thus enablying the two loosely mounted screws to come out of their mounting bracket. I took those two screws out and put them in the new one carefully lining up the screws with the holes in the base element to the support ( this in my mind is the poorest design in an otherwise well thought out assembly ).....once satisfied it was stable, I hooked up the two wires and tested the element using a multi meter. Mine was a series 8 and I installed a series 11 so the wiring was slightly different but easy to figure out. I put the glass back on top again and installed the screws. The module was carefully slid back into place and I retested the element with power.....all was fine.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Radiant Element - 8" - 2000W

Part Number: PS2077799

In Stock