DISHWASHER QUIT RUNNING ON THE PRESSURE SIDE (PUMP MOTOR WENT BAD).

ApplianceWhirlpool Dishwasher

ModelGU2455XTSQ1

Level of DifficultyReally easy

Time to do repair30 - 60 mins

Age of Appliance1 - 4 years

Tools Wrench set
Pliers
Screw drivers
Socket set

JACK From HARDIN, MT

Apr 18, 2009

18 out of 19 people found this instruction helpful

Turned off water and disconnected line, then disconnected drain, turned off power and slid dishwasher out and turned turned upside down and removed hold down bolt ( it is a 3/8 head bolt) removed wire from motor and twisted motor assembly approximately 1/4 turn counter clock wise and removed old motor and seal assembly reinstalled new motor with new seal and rewired. turned washer back upright and removed filter assembly and lower jet arm, removed cover for food disposal and reinstalled disposal blade back on pump drive reinstalled cover and filter assembly and jet arm. slid unit back in place and anchored down to cabinet and turned water and power back on ran washer through a short cycle to clean any soap build up that was left inside and that was it, It all works just like new.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

USE WPL W10239404 (Now subbed to Circulation Pump Motor with Impeller - 60Hz 120V)

Part Number: PS2363114

$147.71
In Stock