washer would walk all over when in the spin cycle

ApplianceKenmore Washer

Model

Level of DifficultyA Bit Difficult

Time to do repair15 - 30 mins

Age of ApplianceMore than 10 years

Tools Screw drivers

Chris From Bonners Ferry, ID

Mar 18, 2009

2 out of 2 people found this instruction helpful

I tried to remove the outer console to get to the tub wear pads easier. This proved difficult for me for some reason. So I tipped the machine on its back at about a 45 degree angle. You will see the tripod support holding up the tub. The pads lie in between the bottom of the tub and on top of the tripod support . You won't be able to see the pads since the are on the top of the support, but you will see the two insert tabs of each pad sticking out. There are about 120 degrees apart from each other. I pushed up on the tub and slipped the piece of wood in between the tub and tripod support close to the pad. Taking a screwdriver and hammer I punched out the wear pad insert tabs. You can replace the old pad with the new one by using some force with your hands. Some pop right in and some you need to use a little leverage, maybe with the piece of wood you used to hold up the tub. Be careful not to get the pads greasy, keep clean as possible. Worked great.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Tub Wear Pads - Package of 3

Part Number: PS334620

$7.38
In Stock

Suspension Spring

Part Number: PS381251

$2.52
In Stock

Spring, Counterweight (Now subbed to Tub Spring)

Part Number: PS2363196

$3.76
In Stock