Burners kept clicking after ignited

ApplianceJenn-Air Range

ModelCVG24020B

Level of DifficultyEasy

Time to do repair30 - 60 mins

Age of ApplianceMore than 10 years

Tools Screw drivers

Robert From Ranchos de Taos, NM

Mar 13, 2009

19 out of 29 people found this instruction helpful

After I bought this part, installed it and the clicking still did not stop I finally found the problem. If your ignitor can still click then it's still good. The problem is the electric connection between the head burners and the base burners (Top Assembly diagram). Put a little weight on the head burner while grabbing it with your hand and grind it into the base burner with a little twisting motion. Repeat for all 4 burners. Presto! (you could be more professional and use steel wool or sandpaper to.)
If you stll want to know how to install this part begin by removing the control panel bracket #24. Then remove the glass top w/seal #9 (after removing the knobs). You may have to tease this out because the rubber seal is sticky. The switch plate #14 comes off after removing 2 obvious screws at each end and 2 not-so-obvious star screws attaching it to the manifold #6. Remove the spark module by removing 2 of the 3 screws and sliding it out of the 3rd screw.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Spark Module

Part Number: PS2201714

$119.12
In Stock