Kenmore Front Load Washer - Would not Drain

ApplianceKenmore Washer

Model

Level of DifficultyReally easy

Time to do repair30 - 60 mins

Age of Appliance5 - 10 years

Tools Pliers
Nutdriver
Screw drivers

Jeffrey From Holly Springs, NC

Feb 12, 2009

2 out of 2 people found this instruction helpful

I used a shop vac to remove the excess water which would not drain from the drum - this is key to not flooding your laundry room. I removed the 2 machine screws at the bottom of the front panel. The panel removes easily which exposes the pump at the front lower right of the washer. I disconnected the electrical connection on the pump. Using the shop vac I slowly removed the hose connectionns at the suction and discharge sides of the pump. Following the disconnect of the hoses screws hold the pump to the base of the washer. Upon removal of the old pump you re-install the new in the reverse order. One item to note is that I purchased 2 hose clamps to replace the spring loaded OEM clamps for the hoses - this greatly aids in reinstallation. Re-install the front cover and you are ready. Total time to repaire 30 minutes - very easy!

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Drain Pump - 60Hz 120V

Part Number: PS2342445

$101.98
In Stock