Motor was overheating and kickins off during the cycle

ApplianceGeneral Electric Washer

Model

Level of DifficultyA Bit Difficult

Time to do repair30 - 60 mins

Age of ApplianceMore than 10 years

Tools Screw drivers
Socket set

Helen From Madison, OH

Feb 12, 2009

11 out of 12 people found this instruction helpful

After turning the water off and removing the hoses,I pulled the top off by removing the 2 screws from the clips in the back and popping the 2 spring clips in the front. I then removed the 2 side screws left and right to allow room for the sides to move out of the way of the motor. The back panel is spot welded so the panels stayed connected. I then removed the 2 screws from the water overflow guard on the motor. Once removed I unplugged the wire harness from the motor. After that the 4 nuts were taken off of the bottom of the motor. I pushed the belt tensioner in and pulled the motor out. Install the motor making sure the nuts are tight as they can work loose from vibration.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

2-Speed Motor with Pulley

Part Number: PS815490

$113.79
In Stock