replacing faulty fan switch

ApplianceJenn-Air Range

Model

Level of DifficultyA Bit Difficult

Time to do repair15 - 30 mins

Age of ApplianceMore than 10 years

Tools Pliers
Nutdriver
Screw drivers
Socket set

Laird From Morrisville, PA

Feb 07, 2009

1 out of 1 people found this instruction helpful

Disable cicuit! remove 2 screws on control housing, lift housing. Remove retaining washers from mounting posts (a trifle difficult, but drill into them with an 1/8" bit...they'll break off enough to grab with needlenose pliers). Mount & wire new switch. The replacement retaining washers are too small...hold them in visegrips & ream the hole with a larger drill bit. Place washer in a magnetic hex drive bit, align over post & tap with hammer to start them, then use a small socket to tap them home. Screw down control housing. Enable circuit...voila!

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Fan Switch Kit (Now subbed to Fan Switch Kit)

Part Number: PS2002868

No Longer Available