The dryer would start to heat then the heat would stop

ApplianceRoper Dryer

Model

Level of DifficultyA Bit Difficult

Time to do repair30 - 60 mins

Age of Appliance5 - 10 years

Tools Wrench set
Nutdriver
Screw drivers

Theodore From Riverside, CA

Feb 06, 2009

9 out of 10 people found this instruction helpful

I changed out the cycling thermostat and the high limit thermostat. Mainly because that was what my research indicated was the problem. I then found some more information online that indicated the gas solenoid valves were bad. I ordered them from you and replaced them. The problem was fixed.

In order to replace the valves you need to remove the top panel. Two screws at the top of the front door assembly hold it on. Remove the screws, lift up on the front panel door assembly and move it to the side. The drum will rest in place. In the lower left corner, under the drum, you will see the solenoids. Two screws attach a plate that holds down the solenoids. Take the hold down plate off, disconnect the control wires attached to the solenoids and lift out the solenoid/control valves. To assemble everything, work backwards to the start. Good Luck

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Secondary Coil Valve - 3 Terminals (Now subbed to 'M' Series New Style Coil Kit)

Part Number: PS334310

$14.26
In Stock

Two Terminal Gas Valve Coil (Now subbed to 'M' Series New Style Coil Kit)

Part Number: PS334310

$14.26
In Stock