The Dispenser would not cut off when dispensing Water and Ice

ApplianceMaytag Refrigerator

Model

Level of DifficultyEasy

Time to do repair15 - 30 mins

Age of Appliance5 - 10 years

Tools Screw drivers

Sue From Garland, TX

Jan 03, 2009

3 out of 4 people found this instruction helpful

1 Remove the two screws at the bottom of the Ice Dispenser faceplate.
2 Carefully remove Faceplate and remove the wire connector on the back side.
3 Remove the three screw holding in the Ice and water dispenser.
4 Disconnect the wire harness going to the dispenser.
5 Remove the Actuator Pad.
6 Unscrew the Limit Switch.
7 There are two wire connectors to be removed. As you remove one place it on the new Switch. Repeat for the other wire.
8 Install the new Limit Switch with the screw that was removed
9 Install the new Actuator Pad.
10 Reconnect the wiring harness to the dispenser.
11 Place the dispenser assembly back in place and reinsert the screws.
12 Carefully reconnect wire harness to the back of the faceplate.
13 Reattach Faceplate to the refrigerator.
14 Install new Dispenser Grill

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Dispenser Grill (Now subbed to Dispenser Grille)

Part Number: PS2058964

$24.23
In Stock

Actuator Pad (Now subbed to Actuator Pad)

Part Number: PS2059931

$15.80
In Stock

Limit Switch (Now subbed to Limit Switch - 2 Terminal)

Part Number: PS2060868

$13.46
In Stock