water was over flowing the holes that are built into the sleeve. causing water to leak out on to floor.

Took the front off the washer. Removed the two screws that hold the top down, this allows the top of the washer to hinge back. The two hose clamps are removed, the hoses slide off the sleeve giving access to the injector and the valve.The new injector has to be placed in the rubber valve and then slid into the plastic sleeve. Tighten up hose clamps and replace top and front of washer. Sleeve had a little different design than orinigal so I figure Maytag had seen this problem before. Almost so easy a caveman could fix it.