Oven would stop heating after a few minutes of operation

ApplianceJenn-Air Range

ModelJGS8850ADB

Level of DifficultyEasy

Time to do repairLess than 15 mins

Age of Appliance1 - 4 years

Tools Pliers

John From Ashland, OR

Dec 16, 2008

2 out of 2 people found this instruction helpful

Heat escaping from the top of the over door would overheat the electronics and cause the system to show error codes F1 and F3-1. Error code F3-1 suggests that the oven temperature sensor was bad. I replaced the sensor but that did not stop the problem. Replacing the oven door gasket stop the heat leak and solved the problem. I simply pull the old gasket off the door (it stuck a bit at the bottom but a pair of pliers solved that problem, then push the new gasket into place without any tools. The old gasket was very hard and non-complient where food had spilled on it and baked hard.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Door Gasket

Part Number: PS2328901

$32.11
In Stock