Timer was inoperative, would not complete wash cycle

ApplianceMaytag Washer

Model

Level of DifficultyReally easy

Time to do repair15 - 30 mins

Age of Appliance5 - 10 years

Tools Nutdriver
Screw drivers

Garry From Port Charlotte, FL

Dec 15, 2008

7 out of 7 people found this instruction helpful

First, I pulled the press-fit knobs for the load size and water temp, then after prying the face cap from the timer knob, I was able to remove the clip, knob and spring portion of the timer knob assembly. Then, I removed four phillips screws at the top of the washer which held the face plate and frame, allowing access to the timer and its wiring harness . The timer was held into position by two small hex screws,which were exposed after the timer knob assembly was remover. I backed themout with a nut driver. After removing the wiring harness, the new timer as very easy to install. I would say it t ook me 10 to 15 minutes to remove, and replace my maytag timer and save over $200 as quoted by a repair service.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

USE WPL 22001538 (Now subbed to Washer Timer)

Part Number: PS2019614

$145.00
In Stock