No "HOT" water when hot water was selected.

ApplianceMaytag Washer

ModelA412

Level of DifficultyReally easy

Time to do repair30 - 60 mins

Age of ApplianceMore than 10 years

Tools Wrench set
Screw drivers
Socket set

Elias From Glendale, CA

Nov 30, 2008

1 out of 1 people found this instruction helpful

First you turn off the main water supply or turn off the valves at the wall behind the washer unit. Second you disconnect the hot and cold water lines going to the washer unit valve. You then use 1/4 closed end wrench to remove one screw. Then you use a flat head screw driver to remove the two screws holding the valve in place. At this point use a 1/4 socket drive to loosen the clamp that is holding the hose that feeds water to the valve. Remove the hose. Then you disconnect the four wires and re-connect the wires to the new valve. Re-install the hose to the valve. Then you are ready to put it all back together.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Water Inlet Valve (Now subbed to Water Inlet Valve)

Part Number: PS1583805

$27.52
In Stock