Replaced electronic clock/control pad

ApplianceJenn-Air Range

ModelJGR8850ADW

Level of DifficultyReally easy

Time to do repair30 - 60 mins

Age of Appliance5 - 10 years

Tools Screw drivers

Alexander From Campbell, CA

Nov 27, 2008

3 out of 4 people found this instruction helpful

First I unplugged the range from the wall outlet and removed the eight screws from rear cover of the control panel. Then I simply pulled the two wires from the small transformer that is attached to the cover panel I had just removed. There is also a ground wire that is held in place by a sheet metal screw. From there it was easy to see the four screws that holds the electronic control pad in place. There are six wires that clip onto the circuit board using spade lugs. I drew simple diagram to be sure I attached the wires correctly after replacing the control pad.

Next, I simply pulled the wires from the control circuit and removed the four screws. I aligned the new control pad and replaced the four screws. I attached the wires per my diagram. Then I positioned the cover panel and re-attached the ground wire as well as the two connections to the transformer.

Finally, I positioned the rear cover panel and installed the eight screws. I plugged the range back into the outlet and everything worked fine. It took me about 35 to 40 minutes to complete the work.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

USE WPL 74008115 (Now subbed to Electronic Control Board with Touchpad)

Part Number: PS2357573

$584.39
In Stock