When moving the washer to install new hoses the elbow for the waste water snapped.

ApplianceMaytag Washer

ModelMaytagWasher

Level of DifficultyA Bit Difficult

Time to do repair30 - 60 mins

Age of ApplianceMore than 10 years

Tools Screw drivers
Socket set

Russell From Cranberry Township, PA

Nov 26, 2008

1 out of 1 people found this instruction helpful

I removed the two screws holding the front panel and lifted out of the way. I then removed the front two bolts holding the top to the frame. I slid the top forward providing access to the interior. I then removed the four screws holding the discharge unit against the back panel. I removed the broken elbow and installed the new one. I reversed the removal procedure and installed the discharge hose to the new elbow. (Note: the new elbow was slightly smaller at the discharge end than the old one. The discharge hose had a larger inside diameter than the elbow. Probably due to the age of the machine). I will pay attention to the discharge hose if I have to move the washer again.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Syphon Break Elbow Kit with Clamp

Part Number: PS2017573

$16.14
In Stock