The washer would stick in between cycles and not continue

ApplianceMaytag Washer

Model

Level of DifficultyEasy

Time to do repair30 - 60 mins

Age of Appliance5 - 10 years

Tools Nutdriver
Screw drivers

Gary From Red Lion, PA

Nov 20, 2008

2 out of 2 people found this instruction helpful

Removed the back panel from the control panel which was 3 phillips head screws and 2 hex screws. Remove the front knob from the timer, this is completed by removing the round center plate on the knob by simply pulling it off and then remove the small plastic pin in the center of the knod underneath the round plate. The pin holds the knob in place and once removed the knob can be pulled off along with the plate behind it.

Now from the back inside the contrlo panel simply unplug the wiring harness from the timer. Remove the circuit board from the timer also, it pulls off easily. There is one hex head screw holding the timer in place and once removed the entire timer assembly can be removed by rerleasing the right side and sliding the assembly to the right and out.

Slide the new timer in place, secure with the hex head screw, reconnect the wiring harness and press the circuit board back in place on the bottom of the new timer. Close up the back panel and replace the front knob components onto the new timer and you are ready to go. In all it took about 40 minutes and saved me over $200 for a service call.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

USE WPL 22003499 (Now subbed to Timer)

Part Number: PS2021083

$103.06
In Stock