Ignitor would glow however gas stove would not light, no gas flow noted..

ApplianceGeneral Electric Range

ModelJGBC20WEA1WW

Level of DifficultyEasy

Time to do repairMore than 2 hours

Age of Appliance5 - 10 years

Tools Nutdriver
Screw drivers

Richard S From Spring, TX

Nov 20, 2008

2 out of 2 people found this instruction helpful

Removed oven racks, removed lower oven shelf panel by using a flathead screwdriver and removed two screws on the back edge of the panel. Removed flat style ignitor (two hex head screws)from the gas burner tube using a 3/16 nutdriver. Disconnected two wires from the ignitor. Removed the two pin connector from the new ignitor, stripped the insulation to expose about a 1/4 inch of bare wire at the ends of the wire where the connector was removed. Installed the ignitor to the gas burner tube using the 3/16 hexhead screws. Connected the wires using porcelain wire nuts. Re-installed the lower oven shelf panel, flathead screws and the oven racks. Oven worked as advertised.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Flat Style Oven Igniter Kit

Part Number: PS231280

$38.36
In Stock