Noise when running and motor stop. Motor bearing overheated.

ApplianceCrosley Dryer

ModelCDG6000W

Level of DifficultyA Bit Difficult

Time to do repair30 - 60 mins

Age of Appliance5 - 10 years

Tools Nutdriver
Screw drivers

Jeffrey From Rogers City, MI

Oct 08, 2008

5 out of 6 people found this instruction helpful

Unplug dryer

Pick the top up at the front and swing up. Inside each side of the front is a screw to remove. Do not forget to unhook the door switch wires. Pull the drum. Push belt off as you remove the drum. Works better to reach in at the lower right and take the belt off of the tighener first.

After you clean out any lint in area unplug the wires from the motor and snap off the hold down clamp on the back bearing.

The blower needs to be released fromt he shaft. The snap ring in front of the blower needs to be taken off. This can be done with a screw driver by prying off the flat spot on the shaft. However, a snap ring pliers would be better. The front of the blower housing must come off as the blower must come off. There is a snap ring behind the blower that must come off also.

The biggest problem I had was removing the front motor bearing housing from the plastic blower housing. It is easy once you see that the front bearing housing is held in by four tabs in the plastic housing. By rotating the front bearing housing 90 degrees you will be able to pull it out.

From there just reverse your action. The belt went on ok. I found by putinng the belt on the drum and the motor drive pully first I was able to reach in an put the belt over the tighener.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Multi Rib Belt - 92-1/4"

Part Number: PS346995

$13.44
In Stock

USE WPL 31001589 (Now subbed to Drive Motor)

Part Number: PS3497647

$190.02
On Order