Parts That Fix Maytag Washer MAV6200AWW Will Not Start
Will Not Start is a commonly reported symptom for the MAV6200AWW Maytag Washer, and we have put together a full guide on how to fix this. This advice is based on feedback from people who own this exact appliance. We have listed the most common parts for your MAV6200AWW Maytag Washer that will fix Will Not Start. We have included repair instructions, and helpful step-by-step video tutorials. If you are experiencing this issue, not to worry, DIYers just like you have fixed this, and shared their experience to help you!
This is a replacement lid switch actuating cam for your washer. The cam is located on the underside of the washer lid, near the hinge. The cam actuates the lid switch, so your washer knows the lid is closed and can begin the cycle. The main reason you would want to replace the cam, is if it is broken, and therefore can’t actuate the lid to begin the cycle. The actuating cam is made of white plastic and is approximately 1 inch wide. It is sold individually, so be sure to determine if the cam is broken or if the problem is with the switch, or somewhere else on the washer.
The pin on the lid pushes on the lever of the lid switch to tell the machine that the lid is closed.
This motor is a 2 speed, 1/2 HP, 120V, 60Hz.
This plunger is part of the lid switch mechanisms and will shut down the spin cycle if the load is unbalanced. When you lift the lid, it resets the plunger and your cycle will resume.
This lid hinge pin is almost two inches long. It is all white in color and is made of plastic.
This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time. If your machine is not draining properly or if it is noisy and shakes during operation, you may need to replace the drain pump. This is a redesigned part. The pump now mounts on to the base of the washer. This product is made of white plastic and has a metal center. Before you can replace the drain pump, you will have to disengage the drive belt under the machine. To reach the drain pump you will need to remove the access panel on the backside of the washing machine.
This drain pump with pulley, also known as the washing machine drain pump assembly, is a pump with two ports. The function of this pump is to help expel water from your washing machine. The pump is activated after the spin speed has been maintained for a specific period of time and is driven by the same drive belt that also runs the transmission pulley. If your washer is not draining properly the pump could be clogged by a small object or could be broken and in need of replacing. Tools you will need for this repair include a 5/16 nut driver, a putty knife, a 3/8 socket with a ratchet, and a pair of slip joint pliers.
Sold individually.