Models
>
MDB7000AWA
MDB7000AWA Maytag Dishwasher - Overview
Sections of the MDB7000AWA
[Viewing 8 of 8]
Keep searches simple, eg. "belt" or "pump".
Silverware Basket - Gray
PartSelect #: PS11743069
Manufacturer #: WP6-918873
This silverware basket is gray in color and measures 8 inches wide by 11-1/2 inches high by 12 inches deep. The silverware basket is used to hold small utensils such as forks, spoons, and knives durin...
$27.75
In Stock
Lower Wheel Assembly
PartSelect #: PS11747717
Manufacturer #: WP99002780
This lower dishrack roller is less than two inches in diameter. It is made entirely of white plastic. If you find that your dishwasher is making loud noises or the lower rack is getting stuck when you...
$12.46
In Stock
Door Gasket
PartSelect #: PS11746830
Manufacturer #: WP902894
This dishwasher door gasket, or door seal, allows the dishwasher door to have an airtight seal when closing the door. No tools are required for this installation, simply remove the existing gasket and...
$69.78
In Stock
Adjustable Peg Clip
PartSelect #: PS11757601
Manufacturer #: WPY912709
This dishrack clip is intended for use with dishwasher dishracks that have adjustable pegs. This clip is only about four inches long.
$11.14
In Stock
White Dishrack Roller
PartSelect #: PS11746834
Manufacturer #: WP903093
This upper dishwasher dishrack roller, also known as a dishrack wheel, allows you to roll the dishwasher rack easily on the support rails. If your dishwasher rack is disconnected or the rack is broken...
$17.19
In Stock
Dishrack Guide Rail Stop - gray
PartSelect #: PS11747648
Manufacturer #: WP99002135
This is a rail stop for your dishwasher. No tools are required for this repair. it simply pops on and off the end of your slide rail when pressing the locking tab. This part is sold individually, so i...
$10.98
In Stock
Door Spring Linkage
PartSelect #: PS11746857
Manufacturer #: WP912653
The door spring retainer is used in dishwashers. It attaches and holds the door spring to the support frame. If your dishwashers door keeps crashing, or both the door and dish rack are falling apart, ...
$11.10
In Stock
Lower Dishrack with Wheels
PartSelect #: PS1960964
Manufacturer #: W10139223
NOTE: Per factory, this substituted part only has 6 wheels instead of 8 and NO longer comes with shelf rack.
$379.66
In Stock
Folding Tines Sleeve
PartSelect #: PS11748488
Manufacturer #: WPW10116789
Sold Individually. White in color.
$10.71
In Stock
Upper Dishrack with Wheels
PartSelect #: PS2099053
Manufacturer #: 99001454
This rack comes complete with four attached wheels and the rack may differ in appearance, but will function same as original part.
No Longer Available
Fold Away Tine Clip
PartSelect #: PS11747606
Manufacturer #: WP99001436
Sold individually. It is recommended to change both tines at the same time.
$11.06
In Stock
Inner Door Foam Insulation Strip
PartSelect #: PS11748543
Manufacturer #: WPW10117748
This genuine inner door foam insulation strip, sometimes known as bottom seal foam, is used to create a waterproof seal that helps prevent leaking from the door area of the dishwasher. The existing in...
$36.28
In Stock
Questions And Answers for MDB7000AWA
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the MDB7000AWA
[Viewing 11 of 11]Leaking
Fixed by
these parts
these parts
Show All
Not cleaning dishes properly
Fixed by
these parts
these parts
Show All
Will not dispense detergent
Fixed by
these parts
these parts
Show All
Door latch failure
Fixed by
these parts
these parts
Show All
Will not fill with water
Fixed by
these parts
these parts
Show All
Will Not Start
Fixed by
these parts
these parts
Show All
Noisy
Fixed by
these parts
these parts
Show All
Not draining
Fixed by
these parts
these parts
Show All
Door won’t close
Fixed by
these parts
these parts
Show All
Not drying dishes properly
Fixed by
these parts
these parts
Show All
Lid or door won’t close
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Water dripping from right corner of door
Took out about 7 torx screws to remove the inner door liner. Discovered evidence of leak coming from the sop dispenser latch, and noticed the grommet had turned soft and was torn. The grommet is only about 1" square. Used nut driver to remove two screws to remove latch assembly. Slipped old grommet off and put new one on, and reattached t
... Read more
he latch. The foam seal at the bottom of the door looked worn, so we replaced it with weatherstripping from home improvement store. The main door seal was brittle, so we replaced it too - just grab an end and pull the old one out. The new one was installed by starting at one end and we just pushed it in place. We used a nut-driver to push it in - we were afraid a screwdriver might damage it. The new door seal required us to latch the door to get it to stay closed the fist couple of days, but now it has loosened up a bit and works as expected. And NO MORE LEAKS. Cost is much less than a new unit!
Read less
Parts Used:
-
Tim from Ringgold, GA
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver
599 of 613 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Rack roller broke
I opened the end stop of the rack, replaced the roller, and put the end stop back on. I can't believe I paid the repairman the last time $125????? An he put in a regular screw that rusted and broke the roller. Took me 3 minutes! Thanks
Parts Used:
-
Kathy from Lombard, IL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Pliers
497 of 502 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The dish rack had two sets of adjustable tines that had never worked.
I ordered two clips just in case. Turns out I needed both of them. Since I hadn't seen the adjustable tines installed, it took some time to figure out how to put the assembly together.
For some reason I had the dishwasher for 7 years before it occurred to me to order the replacement parts. It's much more efficient to use wit ... Read more h the adjustable tines properly installed as I can load approximately 25% more plates than before.
For some reason I had the dishwasher for 7 years before it occurred to me to order the replacement parts. It's much more efficient to use wit ... Read more h the adjustable tines properly installed as I can load approximately 25% more plates than before.
Read less
Parts Used:
-
frank from kenmore, WA
-
Difficulty Level:Difficult
-
Total Repair Time:30 - 60 mins
483 of 491 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!