Models
>
DUS200W
DUS200W Dishwasher - Overview
Models starting with DUS200W
Click on the best match to narrow your results.
Keep searches simple, eg. "belt" or "pump".
Cable and Eyelet
PartSelect #: PS2191503
Manufacturer #: Y03000108
This part helps hold the door in place.
No Longer Available
Screw - 6-32 x 5/16
PartSelect #: PS11744050
Manufacturer #: WP74004005
This screw is well under an inch long, and is made of metal.
$5.36
Special Order
Rocker Switch
PartSelect #: PS2034339
Manufacturer #: 31986601B
This switch is for the oven light and downdraft fan.
No Longer Available
Clamp
PartSelect #: PS11743796
Manufacturer #: WP696392
This screw-type clamp, also known as a hose clamp, is made of metal and is used within various models of washers to secure the tub-to-pump hose and tub/drum of the washer. Without this clamp, the hose...
$7.29
In Stock
Tub Baffle - left side
PartSelect #: PS2017090
Manufacturer #: 2045-0006
This tub baffle is two inches long. It is all black in color and is made entirely of plastic. This baffle is intended for use with some dishwashers.
No Longer Available
Common Symptoms of models starting with DUS200W
[Viewing 2 of 2]Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Both fan and light switches were broken.
TURN OFF POWER TO RANGE AT FUSE BOX -- a)Open the oven door, b) Unscrew the left and right silver nuts (not the black screws)that are in the oven under the control panel, c)pull off the four control knobs on the control panel, d) gently tilt out the control panel, e) set the control panel in/on the protruding arms, f) pull off THE connect
... Read more
ors at the back of the switches - remember which is top and bottom, g) use a screw drive to break off the plastic pieces that hold the switches in place, h) push out the old switches, i) push/snap in the new switches, j) reconnect wires, replace control panel and screw in the nuts.
Read less
Parts Used:
-
Peter from Media, PA
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Pliers, Screw drivers
18 of 23 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Spring that holds door closed
First, removed screws on bottom panel. On this model, everything was easy to see. Did not have to move the appliance at all. The left side wire was broken. Just removed the broken part, connected the new wire, and then the springs to it. No problem at all. Took about 15 mins.
Parts Used:
-
Bessie from Fruitland Park, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Screw drivers
10 of 20 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Wouldn"T Drain The Water Completey
Removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires. . . )
Parts Used:
-
clarence from ST LOUIS, MO
-
Difficulty Level:Really Easy
-
Total Repair Time:1- 2 hours
-
Tools:Pliers, Screw drivers
4 of 6 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!