MTD Chainsaw Parts

Shop By Appliance Type Shop By Part Type

Popular MTD Chainsaw Parts

Your Price

$5.82

MTD Chainsaw Choke Linkage

PartSelect Number PS16427586

Manufacturer Part Number 751P18086

Your Price

$5.19

MTD Chainsaw Primer - Bulb

PartSelect Number PS9912192

Manufacturer Part Number 188-512-1

This is a rubber primer bulb with a plastic adapter attachment that is used on a variety of lawn and garden equipment models. This bulb attaches to the carburetor and is used to pump gasoline from the fuel tank into the gas chamber of the carburetor. Over time and through regular use, the primer bulb will lose its elasticity and may crack, requiring it to be replaced. To replace your primer bulb, you simply need to locate the bulb on your machine, unscrew the housing and remove the bulb, and secure the new one. This bulb is sold as an individual part and has a 2.25cm (7/8-inch) outer-diameter and a 3.33cm (1.3125-inch) height.

Carburetor Float Bowl Gasket – Part Number: 921-04424

Your Price

$7.35

MTD Chainsaw Carburetor Float Bowl Gasket

PartSelect Number PS16453507

Manufacturer Part Number 921-04424

Valve, Roller Over – Part Number: 951-14075A

Your Price

$29.12

MTD Chainsaw Valve, Roller Over

PartSelect Number PS11813571

Manufacturer Part Number 951-14075A

OIL CAP/BULB Assembly – Part Number: 631-04381

Your Price

$4.68

MTD Chainsaw OIL CAP/BULB Assembly

PartSelect Number PS9292425

Manufacturer Part Number 631-04381

Installation Instructions

James from MONROE, NC

It was just a little oil cap for the chain oiler

It was just a little oil cap for the chain oiler Read more...

On - Off Switch – Part Number: 953-08223

Your Price

$3.99

MTD Chainsaw On - Off Switch

PartSelect Number PS12693739

Manufacturer Part Number 953-08223

This on/off switch is an original manufacturer replacement part for chainsaws found on the handle or near the rear of the equipment. It allows the user to start and stop the engine as needed. The switch can wear down over time or experience electrical failure. When the switch fails, the chainsaw may not start or may not shut off when desired, potentially posing safety hazards. Before beginning the repair, ensure that the chainsaw is switched off. Remove the fasteners that secure the switch in place. Disconnect the wire connectors and pull the switch off the equipment. Position the new switch on the mounting surface and reattach the wire connectors. Secure the switch in place with the wiring fasteners and switch the chainsaw on to test that the switch is functioning appropriately.

Your Price

$17.84

MTD Chainsaw Fuel Cap

PartSelect Number PS16469416

Manufacturer Part Number 951-15172

Cylinder Head Gasket – Part Number: 951-14431

Your Price

$16.63

MTD Chainsaw Cylinder Head Gasket

PartSelect Number PS11813651

Manufacturer Part Number 951-14431

This authentic OEM cylinder head gasket in your lawn equipment seals the gap between the engine block and the cylinder head, preventing leaks of combustion gases. Common signs that the gasket is damaged include engine overheating, white smoke or steam coming from the exhaust, or a noticeable decrease in engine performance. If a cylinder head gasket is left unreplaced when it is broken, the combustion gases can escape, causing overheating, warping of the cylinder head or engine block, and potential engine failure. Ignoring a faulty cylinder head gasket can eventually lead to costly repairs or the need to replace the entire engine. Consult your user manual to locate and access the cylinder head for replacement. Remove the old gasket carefully using a scraper, taking care not to damage the mating surfaces. Note that this replacement part is sold individually.