Whirlpool Washer Dryer Combo Circuit Boards and Touch Pads

Your Price

$261.30

Whirlpool Washer Dryer Combo Timer - Washer

★★★★★

1 Review

PartSelect Number PS11742058

Manufacturer Part Number WP3952499

The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.

Your Price

$323.04

Whirlpool Washer Dryer Combo Timer

★★★★★

5 Reviews

PartSelect Number PS871336

Manufacturer Part Number 285938

The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences. Includes mounting screws.

Fixes these symptoms

Will not drain
See more...

Installation Instructions

Joe from Covington, GA

Washer would not wash on "normal" cycle. Had to play with the knob to get it to run at all. Washer would not drain properly either.

I unplugged the washer from the electrical outlet.

I then removed the drain hose from the wall drain to allow me to turn the washer to gain access to the the back panel.

From the front, I then removed the plastic timer knob from the timer by unscrewing it. Then I pulled the plastic plate with the arrow on it to remove it. This exposed the screws that attached the timer to the control panel. I left them attached.

I then removed the two screws on the bottom of the front of the control panel (on each end) that attach the control panel to the washer.

I then went to the rear of the washer and removed the two screws on the top of the rear of the control panel.

I went back to the front and pulled the control panel forward and up to release it from the washer.

I then removed the two screws (that were under the plastic plate) that attached the timer to the panel and removed the timer from the panel.

Then I unplugged the wiring harness from the timer and removed the timer completely.

From there I reversed the procedure to install the new timer and knob. Read more...

Your Price

$210.54

Whirlpool Washer Dryer Combo Washer Timer

★★★★★

4 Reviews

PartSelect Number PS11742012

Manufacturer Part Number WP3948357

The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.

Installation Instructions

Michael from Coeur d'Alene, ID

Washer stops on 1st spin/drain cycle

Unscrew timer/main control knob, then remove 2 spacers behind the knob. Remove 2 main control panel screws at each front lower corner. Rock panel back (pull slightly forward before rocking back to release plastic notches) to expose wire harness and timer. Remove 2 screws holding timer and disconnect timer electrical connector. Put new timer on with screws and attach connector correctly. Rock panel forward into place and reattach panel screws, spacers and knob. Note: Make sure lid switch is working properly before assuming the timer is bad. My switch is also intermittent and needed a shim on lid male plastic piece to engage the switch plate. Read more...

Your Price

$204.71

Whirlpool Washer Dryer Combo Timer

★★★★★

1 Review

PartSelect Number PS11742162

Manufacturer Part Number WP3976569

This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.

Installation Instructions

David from Erie, PA

Timer stuck in on position during drying cycle.

I removed the front control cover, disconnected the timer wires which were color coded, and replaced the new timer. Checked for system operation and everything worked fine. Read more...

Your Price

$195.69

Whirlpool Washer Dryer Combo Timer Kit

PartSelect Number PS11741990

Manufacturer Part Number WP3946432

This timer comes with the installation screws.

Videos!

Your Price

$60.10

Whirlpool Washer Dryer Combo Noise Filter - 275V and 50/60Hz

PartSelect Number PS11753813

Manufacturer Part Number WPW10367632

Fixes these symptoms

Will Not Start
See more...

Your Price

$222.92

Whirlpool Washer Dryer Combo Timer

★★★★★

5 Reviews

PartSelect Number PS11741184

Manufacturer Part Number WP3351744

If the timer you're replacing had threaded mounting holes, you will need self-tapping screws to mount the new timer.

Installation Instructions

John from ARLINGTON HTS, IL

Washer would not advance past wash cycle

Used internet research (Whirlpool support, YouTube videos) to find problem and repair procedure. Timer removal and replacement was simple. The control knob on my washer screws on and off. The knob must be removed before you can remove the timer. Other washers may use a fastener. Read more...