Toro Snow Blower Hardware

Your Price

$4.99

Toro Snow Blower Clamp-Hose

PartSelect Number PS9140678

Manufacturer Part Number 791850

Your Price

$4.99

Toro Snow Blower Key-Flywheel

★★★★★

1 Review

PartSelect Number PS8925657

Manufacturer Part Number 222698S

Your Price

$4.99

Toro Snow Blower Bolt-Shoulder

PartSelect Number PS9046634

Manufacturer Part Number 614650

The Shoulder Bolt is a 3/8-16 x 3-5/8 bolt, certified by the original equipment manufacturer. It is a metal bolt which is individually sold and comes in black. Installation requires a wrench or socket and is rated as "Easy" by customers. It is mostly used to keep the wheel in place. It fits onto the unit frame and if broken or removed, the wheel will fall off. Refer to your make, model and diagram to ensure this is the correct part.

Your Price

$3.99

Toro Snow Blower Screw

PartSelect Number PS9073110

Manufacturer Part Number 690837

Your Price

$3.99

Toro Snow Blower Screw (Blower Housing)

PartSelect Number PS9064541

Manufacturer Part Number 691108

Your Price

$4.99

Toro Snow Blower Fuel Line Clamp

PartSelect Number PS8938782

Manufacturer Part Number 26460

The Fuel Line Clamp is a metal, individually sold part which clamps onto the fuel line, securing it to a port and preventing leaks. Installation is rated as "Easy" by customers and will require pliers and a screwdriver. If broken due to wear/fatigue/damage, there may be a fuel leak and the part should be replaced. Refer to your make, model and diagrams to ensure this is the correct part.

Your Price

$6.52

Toro Snow Blower Screw

PartSelect Number PS9294799

Manufacturer Part Number 692198

Your Price

$4.99

Toro Snow Blower Washer-Sealing

★★★★★

1 Review

PartSelect Number PS8940580

Manufacturer Part Number 271716

Your Price

$5.71

Toro Snow Blower Washer-Sealing

PartSelect Number PS9294812

Manufacturer Part Number 692255

Installation Instructions

FRANK from EASTANOLLEE, GA

Screw can out of the carburator throttle baffel and stuck in the exhaust valve

No compression. Removed the cylinder head. freed the screw, checked the valve to see if it still sealed. Turned the head over with the valves in it, install a spark plug, fill the head dome with gas and see if any leeks out over a 2 hr period. If not you are good to go. Reinstalled every thing with new gaskets and a new carburetor screw. Set the valves to spec. Complete the rebuild and there you have it. Rebuild the carburetor while you have it apart. This motor runs great !!! Read more...