Roper Range Valves

Your Price

$49.31

Roper Range Burner Cap - Black

★★★★★

4 Reviews

PartSelect Number PS11747514

Manufacturer Part Number WP98017461

Sold individually.

Installation Instructions

George from CASTROVILLE, CA

parts missing on a used stove

put in place Read more...

Your Price

$53.87

Roper Range Burner, Top

PartSelect Number PS11747518

Manufacturer Part Number WP98017537

Sold individually.

Installation Instructions

George from CASTROVILLE, CA

parts missing on a used stove

put in place Read more...

Your Price

$241.36

Roper Range Gas Valve

★★★★★

5 Reviews

PartSelect Number PS11752203

Manufacturer Part Number WPW10293048

Once this valve senses the desired heat, it will open up and allow the gas to travel to the oven burner.

Fixes these symptoms

Little to no heat when baking
Will Not Start
See more...

Installation Instructions

Ignatius from Hazelwood, MO

oven wouldn't heat

My oven was misdiagnosed from an appliance repair company. They said my ignitors and spark module needed to be replaced. I did this myself and still nothing. The problem happened to be a defective gas valve.

First I unplugged the stove and shut off the gas supply. After I disconnected the flex hose and the 2 gas connections behind the stove, I removed the 4 screws that held the valve to the back of the stove.

I went to the front of the appliance and pulled out the bottom drawer. This exposed the valve from the other side. I disconnected the electrical connections (3 colored wires) to the valve and removed it. I re-attached the new valve, putting everything back in reverse order. I made sure the 3 wires were reconnected correctly by labeling each one before disconnecting them. I made certain that my gas connections were sealed by using teflon tape and/or pipe sealant from the hardware store. I turned the shutoff valve back to the on position and checked for leaks. If I smelled gas I snugged it down a bit more until no gas smell was detected.

There was nothing wrong with the ignitors or the spark module. The stove failed to pre-heat and the "tick-tick" I used to hear when the stove was first turned on was nonexistent. What the so-called experts said would be hundreds of dollars to fix unded up being a $90 part. Read more...

Your Price

$101.41

Roper Range Burner Tube - Right Front

PartSelect Number PS11747519

Manufacturer Part Number WP98017582

Also called Venturi Tube.

Fixes these symptoms

Gas smell
See more...

Your Price

$59.11

Roper Range LP Spud Kit (For Use With LP)

PartSelect Number PS11748021

Manufacturer Part Number WPW10032010

Your Price

$47.51

Roper Range Burner Cap - Small

★★★★★

2 Reviews

PartSelect Number PS11740923

Manufacturer Part Number WP3191898

Sold individually.

Installation Instructions

Joseph from Matawan, NJ

needed to replace the main top of stove

First I removes all visible screws. The stove top would not budge. I noticed that the elements had screws holding the top in place. These were difficult to remove and all eight screw broke. I then removed the top. I had to remove the broken screws by drilling them out and re-tapping the threads. This was the single most difficult thing to do and took the most time. Once this was complete, re-installing the top was quite simple.
Haviong directions would have been very helpful. Read more...