Hotpoint Microwave Lights and Bulbs

Videos!

Your Price

$22.19

Hotpoint Microwave Halogen Light Bulb - 120V 20W

★★★★★

41 Reviews

PartSelect Number PS2351821

Manufacturer Part Number WB25X10019

This light bulb is located on the inside of your microwave. The bulb is behind the top grill. It will need to be replaced when it has burnt out and no longer works. Unplug the unit before beginning this repair. Remove the top grill of your microwave, use your screwdriver to open the light socket, scrape off any silicone holding the bulb in place, clean the area of any oil and dirt, insert the new bulb into the socket without touching the bulb, slide the holder back into place, line up the tabs on top of the metal plate, and secure the holder back into place.

Installation Instructions

Mark from GRAND BLANC, MI

Lens cracked and bulbs burned out

First I removed the single screw holding the lens assembly in place. Then I lowered the assembly and tilted it until it came out. To remove the existing cracked glass lens there were four tabs bent down on it. By hand I lifted each tab just enough to remove the broken lens. I then replaced the broken lens with the new one and re-bent the tabs down by hand to secure them to the new lens.

The lens assembly, now removed, revealed the cavity that contained the two halogen bulbs. Since they were both burned out for days, they weren't hot so I could pull each one out by hand. The bulbs are secured by two straight heavy gauge wire leads and provided a little resistance but come out fairly easily. Make a mental note of the angle they came out so it will be easier to replace them with new ones.

You're not supposed to touch halogen bulbs with your bare hands, so I used the bubble wrap they came in as a means to hold the bulb while installing it.

Be sure to insert the bulbs at the same angle they came out so the pins do not get bent.

Once both bulbs are in place, replace the lens cover assembly by putting the end opposite where the screw hole goes in first on the right, then swing it up until flush and screw it down. Read more...

Your Price

$21.70

Hotpoint Microwave Halogen Lamp - 50W

★★★★★

15 Reviews

PartSelect Number PS2339783

Manufacturer Part Number WB08X10057

Lamp also known as light bulb. Sold individually.

Fixes these symptoms

Won’t turn on
See more...

Installation Instructions

Sharry from Lititz, PA

Microwave bulb was burnt out

It is easy to repair the burnt out bulb if one has the correct bulb. Your website is very user friendly and your service is great. I was not able to replace the bulb at this time because our RV is at the repair shop for some other matters. I am sure the installation of the new bulb will go smoothly. Thanks for asking. Sharry Kiehl Read more...

Your Price

$37.81

Hotpoint Microwave Light Bulb - 40W

★★★★★

24 Reviews

PartSelect Number PS8767095

Manufacturer Part Number WB25X10030

This is a genuine replacement 40 watt bulb for a microwave. The bulb is meant to light up the underside of the microwave or inside of your microwave when the door is open or during use. If your bulb is not illuminating, you may need to replace it. If the bulb is shattered, be sure to use protective gloves during replacement. Always unplug your microwave before completing any repairs. We suggest ordering a spare, as this is a common wear part.

Installation Instructions

Margaret from TOANO, VA

bulb burned out under the microwave that lights the cooktop underneath

got a screwdriver and opened the glass door over the light bulb - changed the bulb and put the glass door back with the screwdriver. Read more...

Your Price

$22.04

Hotpoint Microwave Light Bulb - 40W 130V

★★★★★

24 Reviews

PartSelect Number PS247209

Manufacturer Part Number WB36X10003

This light bulb is a 40 watt, 130-volt clear appliance light bulb that is manufactured to fit microwaves with small-base light bulb sockets. The light bulb illuminates the inside of the microwave while the microwave is running. You may need to replace this part if the existing one is burnt-out or broken. If the existing light bulb is broken, disconnect power to the microwave and remove the bulb base with a pair of needle nose pliers. This is a common wear item, so it is recommended to order a spare. These light bulbs are sold individually.

Installation Instructions

Gene from Urbana, IL

Light bulb out, tried to remove, lamp socket broke

Above the stove mounted microwave. I dropped the lens cover from under the bulb and tried to remove the bulb. The bulb separated from the base. I tried to remove the base with a pliers and the lamp socket broke. I ordered the parts and dropped the bottom cover of the unit down (5 screws). Removed 1 screww from the lamp socket, unplugged the wires and took it out. Simply replaced socket, fastened bottom cover of microwave, installed new bulb and closed lens cover. Read more...

Your Price

$17.49

Hotpoint Microwave Glass Light Lens

★★★★★

23 Reviews

PartSelect Number PS247275

Manufacturer Part Number WB36X10071

The microwave glass light lens protects the light bulb inside the appliance. It is clear in color and measures approximately 6-1/2 inches long, and 2-1/2 inches wide. You may notice that this part is cracked or broken and will need to be replaced. You will need to remove the screw holding the cover in place. Unhook the cover from the bottom panel. Bend the tabs up that are securing the old lens in place. The textured side should be facing up. Place the new lens into place and secure back into place.

Installation Instructions

Mark from GRAND BLANC, MI

Lens cracked and bulbs burned out

First I removed the single screw holding the lens assembly in place. Then I lowered the assembly and tilted it until it came out. To remove the existing cracked glass lens there were four tabs bent down on it. By hand I lifted each tab just enough to remove the broken lens. I then replaced the broken lens with the new one and re-bent the tabs down by hand to secure them to the new lens.

The lens assembly, now removed, revealed the cavity that contained the two halogen bulbs. Since they were both burned out for days, they weren't hot so I could pull each one out by hand. The bulbs are secured by two straight heavy gauge wire leads and provided a little resistance but come out fairly easily. Make a mental note of the angle they came out so it will be easier to replace them with new ones.

You're not supposed to touch halogen bulbs with your bare hands, so I used the bubble wrap they came in as a means to hold the bulb while installing it.

Be sure to insert the bulbs at the same angle they came out so the pins do not get bent.

Once both bulbs are in place, replace the lens cover assembly by putting the end opposite where the screw hole goes in first on the right, then swing it up until flush and screw it down. Read more...

Your Price

$36.23

Hotpoint Microwave Light Socket

★★★★★

7 Reviews

PartSelect Number PS8753748

Manufacturer Part Number WB06X10929

This light socket is for your microwave and is designed to hold the light bulb. If the light bulb is not working, and the bulb has not burned out, it may be a problem with the light socket. This part is an authentic OEM part sourced directly from the manufacturer. Be sure to disconnect power from the microwave, and consult the manual for your microwave before you make this repair.

Your Price

$23.33

Hotpoint Microwave Light Socket - 250V 75W

★★★★★

19 Reviews

PartSelect Number PS230544

Manufacturer Part Number WB08X10016

This light bulb socket that is used in microwaves. The socket is meant to fit small-base light bulbs. * Please note: The light bulb is not included with this part and is sold separately. If the following symptoms occur, you may need to replace this part: existing socket is broken or cracked, light bulb is not turning on, or new light bulb does not work. Remember to unplug microwave before installing this part and refer to the manual provided by the manufacturer for installation instructions and a detailed diagram.

Fixes these symptoms

Won’t turn on
See more...

Installation Instructions

Gene from Urbana, IL

Light bulb out, tried to remove, lamp socket broke

Above the stove mounted microwave. I dropped the lens cover from under the bulb and tried to remove the bulb. The bulb separated from the base. I tried to remove the base with a pliers and the lamp socket broke. I ordered the parts and dropped the bottom cover of the unit down (5 screws). Removed 1 screww from the lamp socket, unplugged the wires and took it out. Simply replaced socket, fastened bottom cover of microwave, installed new bulb and closed lens cover. Read more...